Post-Backout Steps for CA SDM 14.1.04

This article contains the following topics:
casm1401
This article contains the following topics:
Post-Backout Steps for CA SDM Conventional
Ensure that you are logged in as Administrator to perform the following post-backout steps for conventional configuration:
  1. Navigate to the
     NX_ROOT\site
     folder. 
  2. Open the command prompt window and run the following commands on the primary and secondary servers.
    pdm_perl -pi.old -e "s/resources.created=1/resources.created=0/g" config.properties
  3. To reconfigure the primary and secondary server, run the following command:
    pdm_configure
    Do not select
    Load Default Data
    .
  4. Start CA SDM services.
Post-Backout Steps for CA SDM Advance Availability
Perform the following post-back steps on the standby and application servers for Advance Availability: 
  1. Stop CA SDM Services on all Advance Availability servers.
  2. Log on to the standby server that you will promote as the new background server:
  3. Run the following command on the standby server:
    pdm_configure
  4. Promote the standby server as the new background server by executing the following commands:
    1. To suppress version control on the standby and background servers, run the following command:
      pdm_server_control -v
    2. To promote the standby server as the new background server, run the following command:
      pdm_server_control -b
  5. Run 
    pdm_configure
     command on the new standby server.
  6. Run 
    pdm_configure
     command on all application servers.