Get Started with CA Anomaly Detector

To get started with CA Anomaly Detector, complete the following tasks:
nfa1000
To get started with CA Anomaly Detector, complete the following tasks:
  1. Verify that the installation server meets the following requirements and recommendations:
    • Upgrades: Verify that the existing software is supported for upgrade
    • Operating system
    • (
      Recommended
      ) Hardware specifications.
    • Installation and upgrade prerequisites.
  2. Verify that a supported version of Performance Center is installed in your environment: CA Performance Center supported version, or CA NetQoS Performance Center 6.2.
  3. Install or upgrade to the latest version of CA Anomaly Detector and 
    DX NetOps
    .
  4. Register CA Anomaly Detector as a data source for Performance Center.
  5. (
    CA PC deployment
    ) Enable CA Anomaly Detector configuration functions in the NFA  console.
  6. Add 
    DX NetOps
     and any other products that you want CA Anomaly Detector to monitor.
  7. Enable the monitored products so their data is accessible to CA Anomaly Detector.
  8. Configure the firewalls.
  9. (
    Optional
    ) Review the default sensor configurations and make any necessary changes.
  10. (
    Optional
    ) Configure targets for alerts, to send Syslog or SNMP trap messages when alerts are triggered.