Revert NetOps Portal to Using HTTP

If HTTP-Secure (HTTPS) is enabled for
NetOps Portal
, you can revert
NetOps Portal
to using the default (HTTP) settings.
Follow these steps:
  1. Open a terminal session on the
    NetOps Portal
    host.
  2. Launch the SSL Configuration tool for
    NetOps Portal
    (SslConfig) by issuing the
    ./SslConfig
    command in the
    <installation_directory>
    directory.
    • installation_directory
      The default installation directory for
      NetOps Portal
      .
      Default:
      /opt/CA/PerformanceCenter
      .
    The following image shows SslConfig:
    (22.2.8 and higher)
    SSL Configuration tool prompts
    SSL Configuration tool prompts
  3. At the
    Select your preferred language:
    prompt, specify a language for SslConfig.
  4. At the
    Select your option:
    prompt, enter the number for the option to (22.2.8 and higher) disable SSL (22.2.7 and lower) revert to default settings, and then confirm your selection by entering
    y
    for yes.
NetOps Portal
now uses the default (HTTP) settings.