Access Point (AP) Attributes
The details in the Access Point > Information Tab is populated with relevant values, only when SNMP APs make the association with its WLC. (The values are actually exposed from the WLC MIBs)
The details in the
Access Point > Information Tabis populated with relevant values, only when SNMP APs make the association with its WLC. (The values are actually exposed from the WLC MIBs)
By default, the information displayed in
Access Point > Information Tabis not exposed by SNMP APs.
This is because, Standalone/Autonomous
Access Points(i.e APs not associated to any WLC), do not have this information in its MIBs, and this information is available only from associated WLCs.
To view the details / values in the
Access Point > Information Tab:
- Model the parentWireless Controllerdevice, by enabling Access Point Discovery, using theCreate Wireless Access Pointsoption.
Access Point Informationsub view to populate, a maximum of one polling cycle is required.
The following attributes are displayed when you navigate to
Access Point > Information Tab>
Access Point Informationsub view for an identified and modeled AP, under the
Access Point Information sub view displays the following information:
- AP Type
- Admin Status
- Monitor Only Mode
- Certificate Type
- Operation Status
- AP Model
- Primary Controller Name
- Secondary Controller Name
- Software Version
- Group Vlan Name
- No of connected Users
- Ethernet Mac Address