If you install the robot using the native installers, add the “ip_version” key with value “ipv4 ipv6” in the robot configuration file.

Before you deploy a robot and secondary hub, you must add the environment variable, 

NIM_ROBOT_IP

 and must set the value as 

0:0:0:0:0:0:0:1

 on the machine where UIM is installed. Similarly, you must add this environment variable and set its value before deploying CA UMP. Setting this variable is required for the installer to connect to the primary hub.

To install the robot in a pure IPv6 environment, run the installer as follows, on the UNIX system:

 

(Optional)

 We recommend using hostname instead of IP address for robot installation through USM using an xml file.

 

(Optional)

 We recommend adding IPv6 entries in the host files before using discovery wizard and deploying the secondary robot.

For IPv6 environment, you cannot specify an IP address range for scope. You must specify a single IP address at a time.

With IPv6 UIM installer, addition of any key in hub.cfg is not required. However to manually configure IPv6 environment, add the key IPV6_HANDLING_

ENABLED

, and set the value as 

Yes

. To add the key:

Follow these steps: