DCMT DISPLAY SYSGEN Command

The DCMT DISPLAY SYSGEN command shows all the new lines, terminals and printer definitions that have been added and generated in your system since the last startup or refresh.
idmscu19
The DCMT DISPLAY SYSGEN command shows all the new lines, terminals and printer definitions that have been added and generated in your system since the last startup or refresh.
This article describes the following information:
Syntax
►►─── DCMT ─┬───────────────────┬─────────────────────────────────────────────►             └─ 
broadcast-parms
 ─┘  ►─── Display SYSgen refresh ───────┬─ Lines ────────────────────┬────────────►◄                                     ├─ Line 
line-name
 ───────────┤                                     ├─ STOrage pools ────────────┤                                     ├─ STOrage pool ── 
pool-num
 ─┤                                     ├─ PROgram pools ────────────┤                                     └─ PROgram pool ─┬─ XARP ─┬──┘                                                      └─ XAPP ─┘
Parameters
  • broadcast-parms
    Indicates to execute the DCMT command on all or a list of data sharing group members.
    For more information about broadcasting and
    broadcast-parms
    syntax, see How to Broadcast System Tasks in the Using System Tasks section.
  • Lines
    Displays all newly added line, terminal, and printer definitions, since the last refresh.
  • Line
    line-name
    Displays the named line.
  • STOrage pools
    Specifies that dynamic sysgen changes for all XA storage pools should be displayed.
  • STOrage pools
    pool-num
    Identifies the number of the XA storage pool for which dynamic sysgen changes should be displayed.
  • PROgram pools
    Specifies that dynamic sysgen changes for all program pools should be displayed.
  • PROgram pool XARP/XAPP
    Specifies that SYSGEN changes for the specified program pool should be applied.
    • XARP
      Indicates that SYSGEN changes for the XA reentrant program pool should be applied.
    • XAPP
      Indicates that SYSGEN changes for the XA non-reentrant program pool should be applied.
Example
Issue a DCMT DISPLAY SYSGEN REFRESH LINES command to see a newly generated system definition as shown below:
dcmt d sysgen refresh lines ***  Display Sysgen request *** Line UCFLINE  was modified      Added Pterm/Lterm:  UCFPT05  / UCFLT05
More Information
For more information about system generation, see