U1008

Reason:
ca1tms
Reason:
This abend is uniquely associated with TMSFORMT. (For more information on this utility, see TMSFORMT) The following reason codes are issued in register 15:
Code
Reason
Action
01
Invalid DATEFMT parameter.
Correct the DATEFMT parameter and resubmit the job.
02
CA 1
is not batch active.
CA 1
must be batch active to perform an EXTEND operation on the TMC. For instructions on using TMSINIT to make
CA 1
batch active, see TMSINIT.
03
An invalid volume serial number not in the TMC was encountered during TMSFORMT processing.
Check the TMSFORMT output listings for other associated error messages. If either TMSXITU or TMSXITE has been changed, review these changes and correct the logic.
04
The number of DSNBs in RESTORE Control Record 2 does not agree with the number of DSNBs read.
Execute TMSPTRS to identify the errors causing the problem. After correction, resubmit.
05
A FORMAT operation was requested without PARM=NEW being specified and
CA 1
is not active.
Either add the PARM=NEW parameter to FORMAT the TMC with
CA 1
inactive, or activate
CA 1
before resubmitting your job.
07
TMSFORMT is being used to add a range to a TMC that is in the extended format.
Use TMSXTEND to add a volume range to the TMC.
08
The active Audit dataset was specified in the JCL for DD AUDIT.
If the active Audit dataset must be reformatted,
CA 1
must be placed in an INACTIVE state (Shutdown).