Review Other Migration Information (NA Only)

Review the following migration concerns and act on them as needed, only if you are using nwmau:
nwmscl122
Review the following migration concerns and act on them as needed, 
only
 if you are using 
CA NetMaster Network Automation
:
 
 
Coexistence with Other CA Mainframe Network Management Products
Only one product can have ownership of the Primary Program Operator (PPO) or the Communication Network Management (CNM) interface on a system. When you use 
CA NetMaster Network Automation
 together with 
CA NetMaster NM for SNA
, or Tivoli NetView on the same system, you should review the PPO (for PPO messages) and the CNM (for CNM data) parameter groups to ensure that this product receives the relevant messages and data.
Coexistence with CA NetMaster NM for SNA
Run 
CA NetMaster NM for SNA
 in the same region as 
CA NetMaster Network Automation
. If you run the products in separate regions, specify the 
CA NetMaster NM for SNA
 logon requirements in the EXTAPPLS parameter group.
Same Region Considerations
To run 
CA NetMaster NM for SNA
 in the same region, you should perform the following:
  • Ensure that the RUNSYSIN procedure (created during product setup) includes 
    CA NetMaster NM for SNA
    .
  • Ensure that the RUNSYSIN procedure includes the 
    CA NetMaster NM for SNA
     data sets in the COMMANDS DD.
Separate Region Considerations
Some resource-specific commands are not functional if you run the products in separate regions.
If you need to run the products in separate regions on the same system, you should review the ISRIN parameter group (enter 
/PARMS
). This group enables you to set up proper communications between the two regions.
CNM Data Considerations
To use CNM data, you must initialize the Network Error Warning System (NEWS) in the product region. However, if you have an existing 
CA NetMaster NM for SNA
 region, you can use it concurrently for a while for receiving CNM data from VTAM before combining it with this product.
To receive CNM data from a separate region, identify the link to that region in the ISRIN parameter group (enter 
/PARMS
).
Coexistence with Tivoli NetView
If you want to receive PPO events from Tivoli NetView, switch on the Inter-system Routing (ISR) link to the Tivoli NetView product in the ISRIN parameter group.
If you want to receive CNM data from Tivoli NetView, you must also have 
CA NetMaster NM for SNA
 running in the same region as 
CA NetMaster Network Automation
. Switch on the ISR link to Tivoli NetView in the ISRIN parameter group.