Run the Installation Jobs for a Pax Installation

The members in the following procedure are used to receive, apply, and accept SMP/E base functions.
The members in the following procedure are used to receive, apply, and accept SMP/E base functions. Submit and run these SAMPJCL members in sequence. Do not proceed with any job until the previous job has completed successfully.
The following steps include instructions to execute the
SPLSEDIT for Spool or E0CSEDIT for Java Transformers
macro each time that you open a new SAMPJCL member. To edit all SAMPJCL members simultaneously, read and follow the instructions in the
SPLAREAD for Spool or E0CAREAD for Java Transformers
member, and submit the
SPLEDALL for Spool or E0CEDALL for Java Transformers
member.
  1. Open the SAMPJCL member
    SPL20RCB for Spool or E0C20RCB for Java Transformers
    in an edit session, and execute the
    SPLSEDIT for Spool or E0CSEDIT for Java Transformers
    macro from the command line.
    SPL20RCB for Spool or E0C20RCB for Java Transformers
    is customized.
    If you do not want to install a specific component, comment out the applicable FMID in the RECEIVE job.
  2. Submit
    SPL20RCB for Spool or E0C20RCB for Java Transformers
    to receive SMP/E base functions.
    Your product is received and now resides in the global zone.
  3. Open the SAMPJCL member
    SPL30APB for Spool or E0C30APB for Java Transformers
    in an edit session, and execute the
    SPLSEDIT for Spool or E0CSEDIT for Java Transformers
    macro from the command line.
    SPL30APB for Spool or E0C30APB for Java Transformers
    is customized.
  4. Submit
    SPL30APB for Spool or E0C30APB for Java Transformers
    to apply SMP/E base functions with the CHECK option.
    1. Note any unresolved errors.
    2. Verify that resolving PTFs are applied before implementing products in production.
    3. After successful completion, rerun APPLY with the CHECK option removed.
    Your product is applied and now resides in the target libraries.
  5. Open the SAMPJCL member
    SPL40ACB for Spool or E0C40ACB for Java Transformers
    in an edit session, and execute the
    SPLSEDIT for Spool or E0CSEDIT for Java Transformers
    macro from the command line.
    SPL40ACB for Spool or E0C40ACB for Java Transformers
    is customized.
  6. Submit
    SPL40ACB for Spool or E0C40ACB for Java Transformers
    to accept SMP/E base functions with the CHECK option. After successful completion, rerun ACCEPT with the CHECK option removed.
    Your product is accepted and now resides in the distribution libraries.
You can now clean up the USS directory (optional) or apply preventive maintenance as described in Maintain Products using SMP/E JCL.