Change User Modes

Use the MODE command to change your current access mode, as follows:
view140
Use the MODE command to change your current access mode, as follows:
  • Change to other modes to which you have pre-designated access in the system
  • Change the Distribution Id associated with your predefined User Profile for EXP and SAR Mode
Enter the MODE command with the appropriate parameter on the command line of any Primary Selection panel. Use this format:
MODE mode MODE mode distid MODE distid mode MODE distid
where
mode
is one of the user modes:
  • ALL
  • EXPO (CA Deliver Operations)
  • EXP (CA Deliver)
  • SARO (SAR Operations)
  • SAR
  • JOB
    To view JOB mode data, set the JOBMODE= parameter to YES. Reports that are archived while JOBMODE=YES
    can
    be viewed in JOB mode. Reports that are archived while JOBMODE=NO
    cannot
    be viewed in JOB mode.
where
distid
is a distribution ID that you are allowed to access, given the value of DISTID MASK in your user profile.
If distid contains an embedded blank, parenthesis, quote, or a comma, enclose it in quotes (single or double). Any quote within the Dist-ID must be entered as a pair of quotes because a non-paired quote ends the ID. For example, if the value is JIM’S DESK, enter it as ‘JIM’’S DESK’ or “JIM’S DESK”.
The format is:
MODE EXP distid MODE SAR userid
The following are examples of how to change modes with the mode command:
  • To change to EXP mode from some other mode:
    MODE EXP
  • To change to SAR mode for Distribution Id ACCTCLK:
    MODE SAR ACCTCLK
  • To change to JOB mode from another mode:
    MODE JOB
  • To change EXP Mode Distribution ID to PAYMGR while in EXP Mode:
    MODE PAYMGR