Enabling DMARC reporting

When you set up DMARC sender authentication for inbound mail on the
Spam > Settings > Sender Authentication
page, you can also enable DMARC failure reports. SMG emails a failure report to the domain of the sender whose message failed DMARC validation.
  1. To enable DMARC reporting
  2. In the SMG Control Center, select
    Spam > Settings > Sender Authentication
    .
  3. On the
    Sender Authentication
    page, enable
    Domain-based Message Authentication, Reporting, & Conformance (DMARC)
    .
    You can also limit the external domains whose messages you want SMG to check, or allow SMG to perform sender authentication for all domains.
  4. In the
    DMARC Reporting Settings
    panel, select
    Enable Failure Reports
    .
  5. In the
    Sender Address
    field, type the email address from which the failure reports appear to be sent. The
    Sender Address
    must be a valid address on your email system.
    SMG sends failure reports only to domains that supply an email address in their DMARC DNS records. If a failure report can't be delivered to a domain that supplies an address, your Sender Address mailbox receives a bounceback message.
    • If you want to monitor when failure reports can't be delivered, enter an administrator address as the Sender Address.
    • If you do not want to monitor these delivery failures, enter the address of an email account that is not monitored.
    SMG does not keep copies of the failure reports that it sends.
  6. Click
    Save
    .
The DMARC DNS record of the sender's domain must request forensic reports and must supply an email address to receive these failure reports.
Refer to Anatomy of a DMARC resource record in the DNS at
For more information about DMARC failure reports, visit rfc7489#section-7.3