How to Deploy CA Risk Authentication on Distributed System

Use the CA Risk Authentication InstallAnywhere Wizard to install the CA Risk Authentication components. This Wizard supports Complete and Custom installation types. To install and configure CA Risk Authentication in a distributed environment, use the Custom option when you run the installer.
aa813test
Use the CA Risk Authentication InstallAnywhere Wizard to install the CA Risk Authentication components
.
This Wizard
supports Complete and Custom installation types. To install and configure CA Risk Authentication in a distributed environment, use the Custom option when you run the installer.
Follow these steps:
Keep the following points in mind while installing CA Risk Authentication on a single system or in a distributed environment:
  • Ensure that the
    <install_location>
    does not contain
    any special characters, such as ~ ! @ # $ % ^ & * ( ) _ + = { }[ ] ’ ".
  • Currently, you cannot modify or repair the CA Risk Authentication components by using the installer. To modify the installation, uninstall the component and then re-install it.
  • Do not close the installer window if the installation is in progress. If you click Cancel to abort the installation at any time during the installation, then the installer might not remove
    all
    the directories that it has created so far. You then manually clean up the installation directory, <
    ARCOT_HOME
    >\, and its subdirectories.
  • If you run the installer on a system that already contains an instance of an existing ARCOT_HOME, then:
    • You are not prompted for an installation directory.
    • You are not prompted for the database setup. The installer uses the existing database.
    • You are not prompted to set up encryption.