Performing tasks in the
Thresholds tab
In the
Thresholds
tab, you
can set and edit threshold settings as well as policy settings. You can perform
the following tasks:
- Control the ICMP and SNMP connectivity and performance polling thresholds and of the managed network objects in your network
- Modify thresholds values and groups
- “Policy Settings to control the managed state of interfaces” on page 118:
- TheIP Managerprovides the following threshold settings for IP availability monitoring and IP performance monitoring:
Thresholds settings for
IP availability monitoring
| Thresholds settings for
IP performance monitoring
| Threshold settings for
Control
|
|---|---|---|
Backup Interface Support
| Ethernet Interface/Port
Performance
| |
Connectivity
| Generic Interface/Port
Performance
| |
Dial-on-Demand Interface
Support
| Cisco Fast and NvRam
Memory
| |
Interface/Port Flapping
| Environment
| |
FileSystem
| ||
Juniper Environment
| ||
Processor and Memory
| ||
Temperature settings
| ||
Voltage settings
|
Thresholds tab for IP
Availability Manager shows the Thresholds tab in the Polling and
Thresholds Console connected to an
IP Availability Manager
instance named INCHARGE-AM. The right panel of the
console identifies "Connectivity" as the default setting for the default
"System Resource Group" named "Switches."
Thresholds tab for
IP Availability Manager

Thresholds tab for IP
Performance Manager shows the Thresholds tab of a Polling and Thresholds
Console connected to an
IP Performance Manager
instance named INCHARGE-PM. The right panel of the
console Identifies "Ethernet Interface/Port Performance" as the default setting
for the default "Port Groups - Trunk Ports" group named "1 Gb Ethernet."
Thresholds tab for
IP Performance Manager

Instructions for opening the
Polling and Thresholds Console are presented in
“Opening the Polling and Thresholds
Console” on page 18.