CLI commands invoked on Juniper M/T devices
The CLI show commands for Juniper M/T devices are listed and described in CLI commands for discovery on Juniper M/T devices.
Command | Description | Comment |
|---|---|---|
CLI commands for MPLS discovery | ||
show mpls lsp detail ingress | Shows the configured and active dynamic
LSPs that originate from the device. | |
show mpls interfaces | Shows the MPLS interfaces, their state, and administrative groups. | |
show mpls lsp transit up | match Up | For transit LSPs, shows the incoming and outgoing labels and LSPID. | |
show mpls lsp ingress detail up | match “.” | For ingress LSPs, shows the LSPID, the LSP name, and the full LSP path. | |
show rsvp session ingress | For RSVP-based ingress LSPs, shows the outgoing label, the LSPID,
and the LSP name. | |
show rsvp neighbor detail | match via | For each RSVP neighbor, shows the interface that talks to that neighbor and the IP of the facing interface on that neighbor. | |
show route forwarding-table family mpls | Shows the MPLS forwarding table, including
the incoming and outgoing labels and the outgoing interface. Also identifies load balancing LSPs. | |
show ldp neighbor | Shows peer LDP speakers, their IP address, and the interface used to exchange labels with them. | |
show ldp database | match "--|/32" | Shows the LDP database—only /32 routes (and headers). | |
show ldp route | match /32 | Shows the LDP routes—only /32 routes (and headers). | |
show ldp session detail | Shows LDP session information. | Used to discovernon-targeted LDP adjacencies. |
CLI
commands for L2VPN discovery | ||
show ldp session detail | Shows LDP
session information. | Used to discovertargeted LDP adjacencies. |
show vpls connections extensive | Shows VPLS connection information. | Used to discover
VPLS instances, and to discover and map VLANs to discovered VPLS instances. A BGP-signaled VPLS is also SNMP-discovered; CLI-discovered values do not overwrite SNMP-discovered values. |
show interfaces | Shows status information about the management Ethernet and internal Ethernet interfaces. | |
CLI commands for L3VPN discovery | ||
show route table
<vrf name>.inet.0 | match bgp | Shows the BGP entries in the routing table of each VRF. | |
show routeinstance detail | match “^[^ _]*:$|Router|Type:|- target|Interfaces:|.*/.*/” | ||
show mvpn instance | Used to identify both the multicast group and its relation with the P-tunnel (P2MP LSP). | |
CLI commands for BGP route reflector discovery (JunOS) | ||
show bgp neighbors | match “^Peer:|Type:” | ||