CLI commands for IS-IS monitoring

Because the standards-based IS-IS MIB is used by Juniper devices but not by Cisco devices,
uses:
  • SNMP discovery and SNMP polling to discover and monitor the IS-IS topology for Juniper devices.
  • CLI discovery and CLI polling to discover and monitor the IS-IS topology for Cisco devices.
    The CLI commands that are invoked for IS-IS discovery are identified in the
    , and the CLI commands that are invoked for IS-IS monitoring are described in this section.
    establishes Telnet, SSH1, or SSH2 sessions to the Cisco devices and invokes the following CLI command:
    show clns neighbors detail
    The command provides the target device’s CLNS neighbor interface connections (neighbor IP addresses).