Verifying Configuration
Use the
show serviceengine service_engine_IP_address bgp
command to verify the configuration.The following is an example of the show output:
[admin:controller]: > show serviceengine 10.140.1.13 bgp +---------------------+--------------------------------------------------+ | Field | Value | +---------------------+--------------------------------------------------+ | se_uuid | 10-140-1-13:se-10.140.1.13-avitag-1 | | proc_id | C0_L4 | | name | global | | local_as | 65000 | | vrf | 1 | | active | 1 | | peer_bmp | 2147483648 | | peers[1] | | | remote_as | 1 | | peer_ip | 2006::54 | | peer_id | 1 | | active | 1 | | md5_secret | **** | | bfd | True | | advertise_snat_ip | True | | bgp_state | Established, | | | | | advertise_vip | True | +++ Output truncated +++
The
bgp_state
value in Established
verifies successful BGP peering.VIP | BGP Peer | Placement | SE Infra | SE Remarks |
|---|---|---|---|---|
IPV4 Only | IPV4 IPV6 | Placed | IPV6 Support enabled | |
IPV4 Only | IPV4 IPV6 | Not Placed | IPV6 Support not enabled | |
IPV6 Only | IPV4 IPV6 | Placed | IPV6 Support enabled | |
IPV6 Only | IPV4 IPV6 | Not Placed | IPV6 Support not enabled | |
IPV4 Only | IPV4 | Placed | IPV6 Support enabled | |
IPV6 Only | IPV6 | Placed | IPV6 Support enabled | |
IPV4 IPV6 | IPV4 IPV6 | Placed | IPV6 Support enabled | |
IPV4 IPV6 | Peer 1: IPV4 only Peer 2: IPV6 only | Not Placed | IPV6 Support enabled | |
IPV4 IPV6 | IPV4 Only | Not Placed | IPV6 Support enabled | This is expected behaviour as no matching subnet for IPV6. |
IPV4 IPV6 | IPV6 Only | Not Placed | IPV6 Support enabled | This is expected behaviour as no matching subnet for IPV4. |